ATA8743-PXQW【PDF 161/238 页】MCU W/TRANSMITTER ASK/FSK 24QFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录52

157页 158页 159页 160页 [161页]162页 163页 164页 165页

161

9152BINDCO02/10

ATA8743

25.7 ADC Noise Canceler

The ADC features a noise canceler that enables conversion during sleep mode to reduce noise

induced from the CPU core and other I/O peripherals. The noise canceler can be used with ADC

Noise Reduction and Idle mode. To make use of this feature, the following procedure should be

used:

a. Make sure that the ADC is enabled and is not busy converting. Single Conversion

mode must be selected and the ADC conversion complete interrupt must be enabled.

b. Enter ADC Noise Reduction mode (or Idle mode). The ADC will start a conversion

once the CPU has been halted.

c. If no other interrupts occur before the ADC conversion completes, the ADC interrupt

will wake up the CPU and execute the ADC Conversion Complete interrupt routine. If

another interrupt wakes up the CPU before the ADC conversion is complete, that

interrupt will be executed, and an ADC Conversion Complete interrupt request will be

generated when the ADC conversion completes. The CPU will remain in active mode

until a new sleep command is executed.

Note that the ADC will not be automatically turned off when entering other sleep modes than Idle

mode and ADC Noise Reduction mode. The user is advised to write zero to ADEN before enter-

ing such sleep modes to avoid excessive power consumption.

25.7.1

Analog Input Circuitry

The analog input circuitry for single ended channels is illustrated in Figure 25-8 on page 161. An

analog source applied to ADCn is subjected to the pin capacitance and input leakage of that pin,

regardless of whether that channel is selected as input for the ADC. When the channel is

selected, the source must drive the S/H capacitor through the series resistance (combined resis-

tance in the input path).

The ADC is optimized for analog signals with an output impedance of approximately 10 k?or

less. If such a source is used, the sampling time will be negligible. If a source with higher imped-

ance is used, the sampling time will depend on how long time the source needs to charge the

S/H capacitor, with can vary widely. The user is recommended to only use low impedant sources

with slowly varying signals, since this minimizes the required charge transfer to the S/H

capacitor.

Signal components higher than the Nyquist frequency (f

ADC

/2) should not be present to avoid

distortion from unpredictable signal convolution. The user is advised to remove high frequency

components with a low-pass filter before applying the signals as inputs to the ADC.

Figure 25-8. Analog Input Circuitry

DCn

1..100 k?/DIV>

S/H

= 14 pF

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式